| View previous topic :: View next topic |
| Author |
Message |
lorenzo.mazzante
Junior
Joined: 25 May 2020
Posts: 2
|
 Posted: 25/05/2020 12:13 Post subject: SRVO-280 with robot Fanuc M-10iA without change nothing |
 |
|
Hi,
this morning I power on 2 Fanuc robot M-10iA but I receive the error "SRVO-280 - SOFF input". I take the manual and i sure that EES1 and EES11 are jumpered and EES2 and EES21 are jumped, beacuse I don't use this signal now.
In the next power on, I recieve the error of the reduce aimentation of the condensator.
I used both robot the next week normally without error. WHY NOW???
I attached the photo of Servo Unit and Emergency Unit of one robot and relative guide of the LED. The Servo don't have supply 24V (see the photo) and the Emergency Unit is in error (see the GIF)
P.S. I check that screws located above the LED "V4" and i measured less of 1V. I don't care this is normal.
[url=http://www.99poze.ro/p/a53d2a25049356d7bfa99fca94136e16.jpg] [/url]+[url=http://www.99poze.ro/p/fc481ee15ce0ee29ae7e844aa5b61add.jpg] [/url]+[url=http://www.99poze.ro/p/4e0ad3e51db094a3a6fb50f73d157069.jpg] [/url]+[url=http://www.99poze.ro/p/0bb08d0dc3dee29038d3586ef73274ea.jpg] [/url]+[url=http://www.99poze.ro/p/00e1f9d347be35066b9d9bc0f3574b1e.jpg] [/url]+[url=http://www.99poze.ro/p/39b82b85d4c521dae8795818946ca361.jpg] [/url]+[url=http://www.99poze.ro/p/46f180cfe7386ba05d8c232d7f168bac.jpg] [/url]+[url=http://www.99poze.ro/p/509661d073f9e86c85617432f0a7fa65.jpg] [/url]+ |
|
| Back to top |
|
 |
seaplobykx
Junior
Joined: 03 Oct 2018
Posts: 10
Location: UK
|
| Posted: 25/05/2020 14:35 Post subject: |
|
|
Did someone disconnect the teach pendant with the power on?
This must be disconnected with the power off! Or the cable connector have problems and blown the fuses.
Try to replace the pendant cable and the fuses. |
|
| Back to top |
|
|
lorenzo.mazzante
Junior
Joined: 25 May 2020
Posts: 2
|
| Posted: 25/05/2020 15:44 Post subject: |
|
|
I'm done! Someone turn off the Heavy Duty Safety Switch!! 
See the safety switch MUST BE that solution in the manual!!! Why not??
Thanks for the help! |
|
| Back to top |
|
|
Sully John
Junior
Joined: 30 Dec 2024
Posts: 1
|
| Posted: 30/12/2024 22:56 Post subject: |
|
|
| Start out Simple. Take a small screwdriver and tap your estop from the back a few times. That's what I did and my issues went away. Of course I'm going to replace it now but at least I know what the issue is. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
