plc.myforum.ro

gert · Member 3 Joined: 02 Jan 2015 Posts: 645

Service Bridge – Setting-up and Configuration
https://support.industry.siemens.com/cs/document/109747975/
The Service Bridge is a specially configured switch that allows dedicated temporary access from the plant bus to the fieldbus, while ensuring the logical separation between the fieldbuses. In this entry, you will find the instructions for configuring a SCALANCE XC-200 switch as Service Bridge as well as the prepared configuration files.
For reasons of security and availability, the plant bus and field bus are set up separately from each other in typical process industry plants. This means that only a restricted access is possible to the field bus from the Engineering Station (ES) or Maintenance Station (MS) e. g. via data bus routing by the CPU. Functions such as the manual node designation of PROFINET devices (station name and IP address assignment) or topology scan with the topology editor are thus not available. Consequently, an access point is required which allows access from the ES to the field bus.

The Service Bridge is the solution to allow temporary access from the ES to the PROFINET field bus. The Service Bridge is a specially configured switch that allows dedicated temporary access from the plant bus to the field bus while at the same time ensuring logical separation between fieldbuses.
For security reasons, it is additionally recommended to use a firewall, e. g. in the form of a SCALANCE S, between the plant bus and the Service Bridge.
Service Bridge – Setting-up and Configuration Service Bridge – Setting-up and Configuration

Service Bridge – Setting-up and Configuration Service Bridge – Setting-up and Configuration

Procedure for configuring the Service Bridge
The service bridge is based on SCALANCE XC-200 series switches from FW V3.0.1.
The configuration is made as follows:
Download the prepared configuration file and instructions
Load the configuration file in the switch
Adjust the configuration individually for each plant according to instructions
Documentation
https://support.industry.siemens.com/cs/attachments/109747975/109747975_PCS7_ServiceBridge_DOC_en.pdf
The following ZIP file includes the prepared configuration files for the switches: SCALANCE XC208, XC216 and XC224.
https://support.industry.siemens.com/cs/attachments/109747975/109747975_ServiceBridgeConfigurationFile.zip

The download of the firmware update (FW V3.0.1) for SCALANCE XC-200 is available in the following
https://support.industry.siemens.com/cs/document/109749462/-firmware-update-v3.0.1-for-scalance-xb-200-xc-200-xp-200-xr-300wg

berthold · Junior Joined: 01 Feb 2018 Posts: 6

Service Bridge – Setup and Configuration
https://support.industry.siemens.com/cs/document/109747975/
Procedure for configuring the Service Bridge
The Service Bridge is based on SCALANCE XC-200 series switches from FW V4.0.
The configuration is made as follows:
Download the prepared configuration file and instructions
Load the configuration file in the switch
Adjust the configuration individually for each plant according to instructions
Validity
In this document the use of the Service Bridge is shown with a SIMATIC PCS 7 plant topology. The use of the Service Bridge with SIMATIC PCS neo is possible in the same way.
Download
https://support.industry.siemens.com/cs/attachments/109747975/109747975_PCS7_ServiceBridge_DOC_en.pdf
https://support.industry.siemens.com/cs/attachments/109747975/109747975_PCS7_ServiceBridgeConfigurationFiles_V1_1.zip

https://ulozto.net/tamhle/UvSzcvN3xIfK/