 |
plc.myforum.ro
PLCs users www.plc.myforum.ro!
|
| View previous topic :: View next topic |
| Author |
Message |
doannhat
Junior 2
Joined: 07 May 2013
Posts: 33
|
 Posted: 16/11/2016 15:32 Post subject: S7 1500 with Altivar 630 |
 |
|
Dear all,
Now i'm communicating S7 1500 (profibus card:CP 1542-5)with altivar 630 through profibus.
Hardware confiugre is OK, i use "Profidrive standard telegram 1".
There are two options for this control:
1.Using Control word and Status word to start stop motor and this control is OK.
2.Using MC block, i got a problem at this point. When i use MC-Power to enable Axis, bit "Busy" is true but motor not run.
Can anyone help me about option 2?
Thank All. |
|
| Back to top |
|
 |
vakon
Member junior
Joined: 13 Feb 2016
Posts: 66
|
| Posted: 16/11/2016 19:09 Post subject: Re: S7 1500 with Altivar 630 |
|
|
| doannhat wrote: | Dear all,
Now i'm communicating S7 1500 (profibus card:CP 1542-5)with altivar 630 through profibus.
Hardware confiugre is OK, i use "Profidrive standard telegram 1".
There are two options for this control:
1.Using Control word and Status word to start stop motor and this control is OK.
2.Using MC block, i got a problem at this point. When i use MC-Power to enable Axis, bit "Busy" is true but motor not run.
Can anyone help me about option 2?
Thank All. |
Check Status if TRUE . Check if The setpoint is trully output via an analog output.(measure with an instrument) |
|
| Back to top |
|
|
doannhat
Junior 2
Joined: 07 May 2013
Posts: 33
|
| Posted: 17/11/2016 03:37 Post subject: Re: S7 1500 with Altivar 630 |
|
|
| vakon wrote: | | doannhat wrote: | Dear all,
Now i'm communicating S7 1500 (profibus card:CP 1542-5)with altivar 630 through profibus.
Hardware confiugre is OK, i use "Profidrive standard telegram 1".
There are two options for this control:
1.Using Control word and Status word to start stop motor and this control is OK.
2.Using MC block, i got a problem at this point. When i use MC-Power to enable Axis, bit "Busy" is true but motor not run.
Can anyone help me about option 2?
Thank All. |
Check Status if TRUE . Check if The setpoint is trully output via an analog output.(measure with an instrument) |
Hi,
Status get signal "FALSE". Do i have to configure more thing? |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
Fa-ti si tu propriul forum GRATUIT, pe www.myforum.ro |
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
