plc.myforum.ro Forum Index plc.myforum.ro
PLCs users www.plc.myforum.ro!
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Offset in IEC 104 Addressing

 
Post new topic   Reply to topic    plc.myforum.ro Forum Index -> Other HMI-Reg. U
View previous topic :: View next topic  
Author Message
jyothis.m@gmail.com
Junior
Junior


Joined: 06 Feb 2017
Posts: 5
PostPosted: 26/02/2020 06:10    Post subject: Offset in IEC 104 Addressing Reply with quote
In the SYS600_IEC 60870-5-104 Master Protocol PDF, its mentioned that

"In SYS600 both the input and output process objects share the same address range, which means that there cannot be two process objects with overlapping addresses. If the same address is needed for an input and output object, it can be achieved by using offsets that are outside the information address range limited by the IL attribute."

How can I implement this offset, because in my case there is overlapping address between different process objects coming from the RTU 104 Server.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    plc.myforum.ro Forum Index -> Other HMI-Reg. U All times are GMT + 2 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group
Fa-ti si tu propriul forum GRATUIT, pe www.myforum.ro