| View previous topic :: View next topic |
| Author |
Message |
nguyen xuan khanh
Member
Joined: 16 May 2012
Posts: 170
|
 Posted: 11/03/2021 12:24 Post subject: KUKA ProConOS Soft PLC |
 |
|
I have KRC4 Robot, KR10R1100 C4SR EX2G, 8.3.347.0
and Inside have softPLC
I tried with Workvisual 6.0 with MULTIPROG 5.51, but I see two programs don't compatible together.
Can someone give me any advice? |
|
| Back to top |
|
 |
Slatowsky
Junior
Joined: 29 Oct 2018
Posts: 2
|
| Posted: 11/03/2021 21:15 Post subject: |
|
|
Check compatibility
Software WorkVisual 6.0
KR C4 robot controller:
• KUKA System Software 8.2, 8.3, 8.5 or 8.6
VKR C4 robot controller:
• VW System Software 8.2, 8.3 or 8.6
KR C5 robot controller:
• KUKA System Software 8.7
• Or VW System Software 8.7
Laptop/PC:
• Windows 7
• Or Windows 10
If Multiprog is to be interfaced with WorkVisual:
• KUKA.PLC Multiprog5-51 6.0 must be installed.
Software WorkVisual 5.0
• Windows 7
• Or: Windows 10
If Multiprog is to be interfaced with WorkVisual:
• KUKA.PLC Multiprog5-51 5.0 must be installed.
Software WorkVisual 4.0
Windows 7
Both the 32-bit version and the 64-bit version can be used.
If Multiprog is to be interfaced with WorkVisual:
KUKA.PLC Multiprog 5-35 4.1 must be installed.
Software WorkVisual 3.0
If Multiprog is to be interfaced with WorkVisual:
KUKA.PLC Multiprog 5-35 4.0 must be installed.
Software WorkVisual 2.1
KR C4 robot controller
KUKA System Software 8.2
KUKA.PLC ProConOS 4-1 4.0
KUKA.PLC Multiprog 5-35 4.0 |
|
| Back to top |
|
|
fotamecus
Member
Joined: 06 Nov 2017
Posts: 158
|
| Posted: 12/03/2021 14:12 Post subject: |
|
|
I think You must also install a KOP inside WorkVisual.
And maybe install WorkVisual 5.0 and test from there.
WorkVisual 6.0 and 5.0 (and 4.0, if is the case) can be installed side by side. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
