| View previous topic :: View next topic |
| Author |
Message |
akbar_torkashwand
Member
Joined: 09 Nov 2018
Posts: 228
|
 Posted: 01/05/2019 12:03 Post subject: Error when uploading program from Mitsubishi |
 |
|
I want to upload program from Mitsubishi FX-3U.
But when I connect to PLC I have this error.
THE RANGE SETTING IS WRONG. SET THE CORRECT RANGE, THEN EXECUTE AGAIN. <ES>
https://mega.nz/# !UMB3SYIZ!Wl-542gLJc-HuujP3Yj_WaUzddiJXm10i2NOM3fos1k
what should I do?
Last edited by akbar_torkashwand on 05/06/2019 10:02; edited 1 time in total |
|
| Back to top |
|
 |
Dokizz
Junior
Joined: 16 Sep 2018
Posts: 5
|
| Posted: 01/05/2019 14:05 Post subject: |
|
|
| settings for the number of steps are wrong in the frame project..try to increase from 5K to 10K and try again.. |
|
| Back to top |
|
|
akbar_torkashwand
Member
Joined: 09 Nov 2018
Posts: 228
|
| Posted: 03/05/2019 19:50 Post subject: |
|
|
Thanks so much.
But I don't have source project. I want to upload project from PLC.
Fault LED of my PLC illuminate and RUN LED is off. I want to upload program and online with PLC.
where can I adjust " settings for the number of steps " when I don't have source of program? |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
