| View previous topic :: View next topic |
| Author |
Message |
louie_marc14344
Junior
Joined: 30 May 2018
Posts: 2
|
 Posted: 04/06/2018 11:47 Post subject: eMB-60R undetected |
 |
|
My apologies for being a newbie on this, but could someone save me on this... I have a Viper 650 and an eMB-60R controller which I want to control by ePLC connection using an NJ501-1300 PLC unit, SYSMAC Studio with EIP Adept Library for Robot... All are starting up well, and I connect all components to a switch hub... But following the ePLC guidelines, the IP Address showing on the controller is 172.16.132.111
I change the IPV4 IP Address on the PC settings to 172.16.132.10 and the subnet to 255.255.0.0 but the Adept IP Address Setting Tool on SYSMAC doesn't detect the Robot IP Address, also i tried ipconfig on command prompt which shows a different IP Address IPV4 169.254.197.75 and subnet of 255.255.0.0, I changed the previous setting on the PC setting to 169.254.197.10 with the same subnet. But still PC doesn't recognize. I tried both configurations if ACE Software can detect it but the same ACE can not detect it also... Appreciate any thoughts on what's wrong in my configurations. Thank you. |
|
| Back to top |
|
 |
otb
Junior
Joined: 04 Jun 2018
Posts: 6
|
| Posted: 04/06/2018 18:36 Post subject: |
|
|
Try to use a narrower subnet mask
PC
IP address 169.254.197.10
Subnet mask 255.255.255.0
Robot Controller
IP address 169.254.197.75
Subnet mask 255.255.255.0 |
|
| Back to top |
|
|
louie_marc14344
Junior
Joined: 30 May 2018
Posts: 2
|
| Posted: 04/06/2018 23:26 Post subject: How to edit the subnet for the controller? |
|
|
| Appreciate the insight, but the one where you edit the IPV4 in the PC lan settings is for the PC, yes? How do I edit the subnet for the controller? |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
