| View previous topic :: View next topic |
| Author |
Message |
choi07
Junior
Joined: 10 Jan 2019
Posts: 3
|
 Posted: 31/01/2019 03:53 Post subject: converting Mr J3 to Mr J4 |
 |
|
Good day sirs,
i am a newbie at this motion controller setting. I would kindly like to ask for an assistance from all of you. i copied all the necessary data that i have on this project. I installed the wiring correctly i am able to Jog the servo motor. But when i try to Jog the motor Using GXWorks 2 i wasn't able to do so because its not showing any movement on the Mr J4 and the motor it self. is there any settings that i should have change? thank you for the time if you will need any information i am willing to give it thank you |
|
| Back to top |
|
 |
dG
Junior
Joined: 30 Jan 2019
Posts: 1
|
| Posted: 31/01/2019 23:57 Post subject: Transition from MELSERVO-J3 Series to J4 Series Handbook |
|
|
Transition from MELSERVO-J3 Series to
J4 Series Handbook
http://dl.mitsubishielectric.com/dl/fa/document/catalog/servo/l03127/l03127a.pdf |
|
| Back to top |
|
|
choi07
Junior
Joined: 10 Jan 2019
Posts: 3
|
| Posted: 04/02/2019 03:35 Post subject: Re: Transition from MELSERVO-J3 Series to J4 Series Handbook |
|
|
| dG wrote: | Transition from MELSERVO-J3 Series to
J4 Series Handbook
http://dl.mitsubishielectric.com/dl/fa/document/catalog/servo/l03127/l03127a.pdf |
Thank you for the reply i checked the whole parameters and it is as follows i think i have a problem on programming the QD75P4N. Because i was able to Jog the motor using the mr J4 and only the pulse on the QD75 is my problem.
Pls help thank you |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
