plc.myforum.ro Forum Index plc.myforum.ro
PLCs users www.plc.myforum.ro!
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

ANALOG OUTPUT ET200SP

 
Post new topic   Reply to topic    plc.myforum.ro Forum Index -> Simatic Automation Systems
View previous topic :: View next topic  
Author Message
edimar83
Junior
Junior


Joined: 31 May 2017
Posts: 8
PostPosted: 19/01/2023 18:55    Post subject: ANALOG OUTPUT ET200SP Reply with quote
Hello. I have an application on a cpu 315 PN/DP which communicates via PROFIBUS DP with a remote ET200SP with some DI, DO and AO cards. I was able to establish communication and the network is working normally. I tested the digital input and output signals and they are all ok. The problem is with the analogue output card, which does not output 4mA, even though I write to the address corresponding to the channel. I'm using the MOVE block. According to the card's manual, I should write 27648 in its INT to go to 100% (20mA) right? Any tips? 6ES7135-6GB00-0BA1, TIA V17.[/img]
Back to top
View user's profile Send private message
Daffysco
Junior
Junior


Joined: 03 Dec 2022
Posts: 2
PostPosted: 20/01/2023 20:45    Post subject: Reply with quote
I tried to simulate a project with analog out and get error.
Something is wrong in TIA Portal :-| :-|
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    plc.myforum.ro Forum Index -> Simatic Automation Systems All times are GMT + 2 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group
Fa-ti si tu propriul forum GRATUIT, pe www.myforum.ro